DESCRIPTIONS?

The sliding gate opener kit works with gates up to 40 feet long and weighing 1400 pounds. There is an option for auto-closing with this system. After opening, you can set the gate to close in 12, 24, or 36 seconds. This system can be controlled by up to 20 extra remotes. In order to prevent replay attacks, the gate uses an RF hopping code that makes it impossible for eavesdroppers to record the transmission and replay it later. Level ground is required for the gate to operate; slopes are not allowed. A manual release key may also be used in an emergency or power outage.

FEATURES?

Our sliding gate opener is powered by an AC motor. A 200W power supply powers it. Bearings with a capacity of 1400 pounds can be used due to the high torque and capacity.
By using any of the buttons on the remote, you can toggle through the actions OPEN, STOP, CLOSE, and STOP without conflicting orders. A gate opener can be controlled by up to 20 remotes.
There is an option to automatically close this system. It is possible to set the gate to close after 12 seconds, 24 seconds, or 36 seconds after it opens. In pedestrian mode, the gate will open approximately 1-5 feet for people to pass through.
In order to prevent replay attacks, the gate uses an RF hopping code, which prevents eavesdroppers from recording the transmission and replaying it later.

SPECIFICATIONS:

 The maximum gate weight is 1400 pounds
Gate Length: 40ft (chain length: 20ft)
110V AC, 60Hz power supply
The gate moves at a speed of 43 feet per minute (8.5 inches per second).
55 RPM is the motor speed
200 Watts of output power
Range of remote control: 100 feet (Frequency: 433.92 MHz)
48mm is the height of the output shaft
The maximum gate weight: 1400lbs
16Nm of output torque
A magnetic limit switch is used as a limit switch
57 dB of noise
The maximum number of remotes is 20
 S2, 15-minute duty cycle
Temperature range: -4°F~+122°F (-20°C~+50°C)

PACKAGE LIST

1*Sliding gate opener
2* Manual release keys
2* Remote controls
1*Box of accessories (2x 3M chains and a screw kit)