DESCRIPTION?

It works with sliding gates up to 40 feet long and weighing 1400 pounds. There is an auto-close option available with this system. In 12 seconds, 24 seconds, or 36 seconds after opening, the gate can close. It is possible to add up to 23 extra remote controls to this system. To prevent replay attacks, it uses an RF hopping code, which makes it impossible for eavesdroppers to record the transmission and replay it later. Sloped ground cannot be used to operate the gate. If there is a power outage or an emergency, you can also use a manual release key.

FEATURES?

We use an AC motor to operate our sliding gate opener. It is powered by a 200W power supply. With its high capacity and big torque, it can support up to 1400 pounds of load.

You can toggle between the actions OPEN, STOP, CLOSE, and STOP by using any of the remote's buttons. There can be up to 20 remote controls for one gate opener.

There is an auto-close option available with this system. The gate can be set to close in 12, 24, or 36 seconds after it opens. In the pedestrian mode, the gate will open about 1-5 feet for people to pass through.

A RF hopping code prevents replay attacks, which makes it impossible for eavesdroppers to record the transmission and replay it later.

SPECIFICATIONS:
Gates must not exceed 1400 pounds in weight

The maximum gate length is 40 feet (including 20 feet of chain)

110V AC, 60Hz power supply

The gate moves at a speed of 43 feet per minute (8.5 inches per second).

55 RPM is the motor speed

200 Watts of output power

The range of the remote control is 100 feet (the frequency is 433.92 MHz)

The output shaft height is 48mm

The max gate weighs 1400 pounds

16Nm of output torque

Magnetic limit switch

The noise level is 56 decibels

20 maximum remotes

S2, 15-minute duty cycle

The operating temperature range is -20°C to 50°C (-4°F to 122°F).

PACKAGE LIST
An opener for sliding gates
Keys for manual release
Controls for two remotes
2 x 3M chains and a screw kit in a box